This thread is an example written by the BLOWZER Team — a template, not a real print. Copy the shape of it when you post yours.
Design: <name and version — e.g. Desk Dock v3> Printer / material: <printer model> · <PLA / PETG / …> · <layer height> · <walls / infill> · <supports yes/no> Print time: <hours>
Fit:
- Grip pocket: <snug / loose / tight — how much play, in mm if you measured it>
- Barrel rest or cups: <touches / clears — where>
- Charging slot: <cable fits / needs widening>
What I would change: <one or two lines>
Photo: <one wide shot on a flat surface, one close-up of the fit>
That is all a fit report needs. Post it as a Show your print reply on the design's own thread so it counts on the MOD page, or as a new thread in 3D printing when it is about the settings rather than one design.