Seven mounts, every one designed from the factory CAD so the pockets match the real product (grip 50.6 × 28.5 mm, barrel Ø39.7 mm, 149.2 mm tall; 0.6 mm of clearance around the grip). Files, print notes and the reuse licence are on each design's page in the MODS library (https://community.getblowzer.com/mods). Status, honestly: all seven are fit-checked digitally against the product CAD; as far as our record shows none has been test-printed yet — if you print one, post a Show your print reply on its thread.
| Mount | Where it goes | Filament | Supports | Hardware | |---|---|---|---|---| | Desk Dock (190 × 100 × 44 mm) | on a desk, upright, the four spare nozzles twist-locked onto bayonet seats; charges while docked | ~124 g PLA | none | optional rubber feet | | Wall Mount (80 × 161 × 47 mm) | a wall or cabinet side; two keyholes 110 mm apart; charges on the wall | ~73 g PLA | none | 2 × #8 (4 mm) screws | | Upright Stand (110 × 80 × 36 mm) | the tidiest desk option, a small pedestal; charge-through | ~74 g PLA | none | — | | Snap Clip (70 × 90 × 36 mm) | the lightest wall or pegboard option: push in, click, pull up | ~37 g PETG | none | 2 × #8 (4 mm) screws | | Magnet Puck (Ø80 × 42 mm) | any steel surface — PC case side, toolbox, workbench leg, car tailgate | ~38 g PLA | none (bridging on) | 6 × Ø8 × 3 mm N42 magnets | | Belt Holster A — drill hook | a 50 mm work belt; the grip drops through a ring | ~23 g PETG | yes, heavy | — | | Belt Holster B — gunslinger | a 50 mm belt, barrel nozzle-down in a channel | ~24 g PETG | some | — | | Belt Holster C — clip-on | a 50 mm belt, snap jaws on the grip | ~42 g PETG | none | — |
Two things to know before you choose: the leaning tilt stand is deliberately not published — it tips over at about a 10° nudge, the upright stand takes about 24°. And the three belt holsters are concepts: never printed or worn yet, and holster A needs a lot of support material in every orientation. Print at 100 % — scaling changes the grip pocket and it stops fitting.
Models in this post
Upright desk dock: the four spare nozzles twist-lock onto bayonet seats, charge-through USB-C, 20 % less material.
Screw-on wall holster: grip pocket plus a flat barrel rest, charges on the wall.
Lightest wall or pegboard clip: push the grip in, it clicks; pull up to release.
Round screwless dock that sticks to any steel surface with six magnets.